The selection of cutting guides should follow certain principles. Whether it is the selection of materials or the unified standards, it is helpful for us to select better cutting guides. A good machine is the basis of production, and a cutting guide with excel……

Adjustment of the five-cut guide before installation, the centering of the front and rear guide wheels should be the same. The five-cut guide does not make corresponding adjustments to the center. The opening of the guide should be adjusted. The guide should b……

The calculation of the torsion angle of the torsion guide is an important step that must be carried out. If this step is omitted or the calculation is inaccurate, the torsion device will not be used, which will not only cause waste but also easily delay the pr……

The torsion guide is mainly used to guide the elliptical or rectangular rolled pieces from the rolling mill, and set a certain torsion angle value according to the distance of the next stand, so that the rolled piece can be twisted 90 degrees and correctly rol……

Usually, in order to fix the entrance guide plate, exit guide plate and lower guard plate, the lower crossbeam is installed on both sides of the entrance and exit of the mill. Only the lower crossbeam is installed on the two-roll mill, and the upper and lower ……

The crossbeam of the slitting guide is mainly used to support and fix the guide device, so the crossbeam not only needs sufficient strength, but also requires the crossbeam to be firmly fixed on the rolling mill frame. So how to fix it, what are the common met……